High safety AC current clamp for
DMM's Fluke
Current clamps are the ideal tools to extend the functionality of
Fluke Tools. The i400 is a single range 400Amp AC current clamp
with current output via safety shrouded banana plugs. The clamp is
compatible with most Fluke multimeters or any other current
measurement device that accepts 4mm-shrouded banana plugs and has
an AC milliamp range. The division ratio is 1000:1.
Companion to your DMM
to measure up to 400 Amps AC.
1mA/Amp output
guarantees easy reading on your meter.
Only current clamp
available with a CAT IV 600V, CAT III 1000V rating.
Specially designed to
offer maximum utility in a very compact shape.
Take accurate current
readings without breaking the circuit.
Soft non-slippery
overmold handle prevents from accidental touching live wiring.
Maximum conductor
diameter 32mm.
Nominal Current Range
400 Amps
Continuous Current
Range
1 Amp to 400 Amps
Maximum Non-Destructive
Current
1000 Amps
Lowest Measurable
Current
1 Amp
Basic Accuracy
2% +0.06 amp (45Hz to 400
Hz)
(% of reading + floor-spec)
Useable Frequency
5 Hz to 20 kHz
Output Level(s)
1mA/amp
Safety
CAT IV, 600 Volt, CAT III,
1000 Volt
Maximum Voltage
1000 volts AC rms from
earth to ground, in compliance with EN61010
