Number of Phases
 

Weight
 

Size (H x W x D)

On-board Printer

Display

Color, 144mm (5.7"), 320 x 240 pixels

Bandwidth

DC to 3MHz or DC to 10MHz depending on input module

Basic Accuracy

0.2%, 0.1% or 0.03% depending on input module

Sampling Rate

0.33MHz or 1MHz depending on input module

Voltage Input Range

0.3V to 1000V

Current Input Range (direct, not via shunt)

0.03mA to 20A depending on input module

Memory for Configurations

4MB (up to 15 user configurations can be saved into a permanent memory and reloaded later on). Changes that were not saved are lost after switching off the instrument.

Memory for settings

0.5MB

Fast Fourier Transformation (FFT)

To the 40th harmonic

RS232/USB Interface

Standard (RS232 interface for upload of firmware and data exchange with the PC. A printer can be connected over an external converter.

PI1 Process interface (8 analog/impulse inputs and 4 analog outputs)

Optional

IEEE488.2/GPIB interface (1MBit/s) Ethernet (10MBits/s or 100MBits/s)

Optional

Fluke NormaView PC software (for data download, analysis and report writing)

Standard

Working Temperature Range

-5°C to 35°C (41°F to 95°F)

Storage Temperature Range

-20°C to 50°C (-4°F to 122°F)

Housing Material

Fluke Norma Power Analyzers are extremely compact and equipped with a solid metal case to meet stringent EMC requirements.

Climatic Class

KYG DIN 40040, max. 85% relative humidity, non-condensing

Power Supply

85V to 264V AC, 50/60Hz, DC 100V to 260V, ca. 40VA European plug with switch. Binding post for current available on some models.

Measuring Inputs

Safety sockets 4mm, 2 for each input. External shunt connection over BNC socket.

Operation

Membrane keyboard with cursor - function keys and direct functions.

Connections

Rear panel of the 3-phase Analyzer

Range

DC and 0.2Hz to sample rate

Accuracy

±0.01% of measured value (reading)

Synchronization

• Channels which can be selected: all U/I or external input.
•One of three low pass filter with different frequencies can be  switched into the signal.     
• The frequency is always visible on the top of the screen.
• The BNC synchronization socket on the rear of the instrument can be used either as input or output.
• The input signals can be measured up to the sample rate of the power phase. The maximum level must not be higher than 50V.
The output signal is a pulsed 5 volts TTL signal (frequency depends on the measured synch frequency.

Electrical Safety

EN 61010-1, 2nd Edition 1000V CAT II (600V CAT III)
Degree of pollution 2, safety Class I
EN 61558 for transformer
EN 61010-2-031/032 for accessories

Maximum Input

For voltage inputs Measurement range 1000V_eff, 2kV_peak
For current inputs Measurement range 10A_eff, 20A_peak

Test Voltage

Electromagnetic Susceptibility

Emission: IEC 61326-1, EN 50081-1, EN55011 Class B
Immunity: IEC 61326-1/Annex A (industry sector), EN 50082-1